Attached you can find a small circuit diagram with Schottky diodes, to realize a Swiss Backlight. Complete with switchable red light. The whole works only with LEDs! Licht Schweiz + rot.pdf Here with additional Shunting light: Licht Schweiz + rot+rangierlicht.pdf
With transistors, the function outputs F5-F8 can be operated with a higher current. Here is an example of the XLS. The polarity of a resistor (1KOhm) does not matter. The polarity of the transistor must be observed!
Here is a simple conversion suggestion for the old LGB-2×430 locomotives (Ge 4/4-II) without interface. With an additional 24V relay you can simply use the old pantograph control. The three-pole cable from the lower part to the upper part is removed. The electronics (motor control) in the lower part are replaced by the XL / XLS decoder. The white + brown cable is connected to the decoder via the…
On several occasions, we set up a circuit here to digitize the old DUO locomotives with electric decouplers. The circuit was tested by me once on an XL decoder and worked and is in this form only for one drive usable. Nevertheless, I can give no guarantees for replicas, this is at your own risk. The circuit must be doubled for both drives. The function output of the decoder…
Here we will explain how to realize a Ditchlight. A Ditchlight are 2 lights of the front light, which blink alternately when operating bell / horn. Here the circuit for a Ditchlight. The values of the resistors have to be adjusted. The following CVs have to be programmed using a XLS and when triggering the Ditchlights should take place on key 1: CV 113=1 (A3 at Key 1) CV…
Dear customers, the technical hotline will not be available…
Deutsch
