Old 3pin Switch-drive
If you have old 3-pin Switch-drives from LGB, you can control this with our 4 channel-switching decoders. Here is a sketch how to connect it: The switching time should be set down a little in CV 51-58 (Value 66).
If you have old 3-pin Switch-drives from LGB, you can control this with our 4 channel-switching decoders. Here is a sketch how to connect it: The switching time should be set down a little in CV 51-58 (Value 66).
Sorry, this entry is only available in German.
If you would like to control the Uncoupler with the outputs A5-8 from the XL / LS / XLS, you need a small additional circuit for controlling the Uncoupler. See picture with schematic. The circuit can be easily mounted on a stripboard. P.S.: The L decoder does NOT require this circuit!
Attached you can find a small circuit diagram with Schottky diodes, to realize a Swiss Backlight. Complete with switchable red light. The whole works only with LEDs! Licht Schweiz + rot.pdf Here with additional Shunting light: Licht Schweiz + rot+rangierlicht.pdf
With transistors, the function outputs F5-F8 can be operated with a higher current. Here is an example of the XLS. The polarity of a resistor (1KOhm) does not matter. The polarity of the transistor must be observed!
Here is a simple conversion suggestion for the old LGB-2×430 locomotives (Ge 4/4-II) without interface. With an additional 24V relay you can simply use the old pantograph control. The three-pole cable from the lower part to the upper part is removed. The electronics (motor control) in the lower part are replaced by the XL / XLS decoder. The white + brown cable is connected to the decoder via the…
On several occasions, we set up a circuit here to digitize the old DUO locomotives with electric decouplers. The circuit was tested by me once on an XL decoder and worked and is in this form only for one drive usable. Nevertheless, I can give no guarantees for replicas, this is at your own risk. The circuit must be doubled for both drives. The function output of the decoder…
Due to conversion and maintenance work, the WIKI is currently not available. We will inform you here as soon as the WIKI is online again and apologize for the circumstances.
The sound project of the BR 50 (XLS 8210560) has now been available for about 2 weeks – with the latest update we have optimized the reproduction of the steam chuffs and provided it with a new dynamic, so that we have continuously harmonic steam chuffs, even at high speed. The sound project of the Emma (82×0570) has also been revised and is available for download via the MST….
Here we will explain how to realize a Ditchlight. A Ditchlight are 2 lights of the front light, which blink alternately when operating bell / horn. Here the circuit for a Ditchlight. The values of the resistors have to be adjusted. The following CVs have to be programmed using a XLS and when triggering the Ditchlights should take place on key 1: CV 113=1 (A3 at Key 1) CV…